Wifi Power Cycle - Dell Precision 3541 Service Manual

For example, the power and battery-status light blinks amber two times followed by a pause, and then blinks white three times followed by
a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.
The following table shows different power and battery-status light patterns and associated problems.
Table 4. LED codes
Diagnostic light codes
2,1
2,2
2,3
2,4
2,5
2,6
2,7
2,8
3,1
3,2
3,3
3,4
3,5
3,6
3,7
Camera status light: Indicates whether the camera is in use.
• Solid white — Camera is in use.
• Off — Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
• Solid white — Caps Lock enabled.
• Off — Caps Lock disabled.

WiFi power cycle

About this task
If your computer is unable to access the internet due to WiFi connectivity issues a WiFi power cycle procedure may be performed. The
following procedure provides the instructions on how to conduct a WiFi power cycle:
NOTE: Some ISPs (Internet Service Providers) provide a modem/router combo device.
Steps
1. Turn off your computer.
2. Turn off the modem.
3. Turn off the wireless router.
4. Wait for 30 seconds.
5. Turn on the wireless router.
6. Turn on the modem.
7. Turn on your computer.
Problem description
Processor failure
System board: BIOS or ROM (Read-Only Memory) failure
No memory or RAM (Random-Access Memory) detected
Memory or RAM (Random-Access Memory) failure
Invalid memory installed
System-board or chipset error
Display failure
LCD power rail failure. Replace system board
Coin-cell battery failure
PCI, video card/chip failure
Recovery image not found
Recovery image found but invalid
Power-rail failure
System BIOS Flash incomplete
Management Engine (ME) error
Troubleshooting 95