Display Bezel; Removing The Display Bezel - Dell Precision 3541 Service Manual

Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Connect the display cable to the system board and adhere the tape to secure the display cable.
5. Place the EDP metal bracket on the display cable connector.
6. Replace the two (M2x3) screw to secure the EDP metal bracket to the system board.
7. Connect the touchscreen cable to the connector on the system board.
8. Replace the six (M2.5x4) screws that secure the display hinge to the chassis of the computer.
9. Route the WWAN cable and the WLAN cable through the retention clips provided.
Next steps
1. Install the WWAN card.
2. Install the WLAN card.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in

Display bezel

Removing the display bezel

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the WWAN card.
6. Remove the display assembly.
About this task
The figure indicates the location of the display bezel and provides a visual representation of the removal procedure.
82 Disassembly and reassembly
After working inside your computer.
Before working inside your computer.