Planet WGSW-48000 Quick Installation Manual page 8

48-port 10/100/1000base-t with 4 shared sfp managed gigabit switch

n Configure IP address

3. On "Switch#" prompt, type "configuration" to enter into global configuration

mode.

4. On "Switch(Config)#" prompt, enter the following command and press

<Enter>. As show in Figure 5-2.

Switch(Config)# network parms 192.168.1.100 255.255.255.0

192.168.1.1

The previous command would apply the follow settings for the Managed Switch.

IP: 192.168.1.100

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.1

5. Repeat Step 1 to check if the IP address is changed.

6. On "Switch#" prompt, type "Save" to save the current configuration.

If the IP is successfully configured, the Managed Switch will apply the new IP

address setting immediately. You can access the Web interface of WGSW Managed

Switch through the new IP address.

If you do not familiar with console command or the related param-

eter, enter "?" anytime in console to get the help description.

Note

Figure 5-2 Set IP address screen

Table of Contents