Transportation, Storage And Disposal - Jonsered FR 2318 FA 4x4 Operator's Manual

Problem
There is vibration in the product
The cutting result is unsatisfacto-
ry
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
26
Cause
The blades are loose. See
One or more of the blades are unbalanced. See
22 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
16 .
The tire pressure is different on the right and left sides. See
page 20 .
The product is operated at a too high speed. See
14 .
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

To examine the blades on page 22 .
To examine the blades on page
To examine the blades on page 22 .
To get a good result on page 14 .
To get a good result on page 14 .
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission when you tow. See
engage and disengage the drive system on page 12 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If you
keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
mixing ratios given by the manufacturer. Run the engine
for a minimum of 10 minutes after you add the stabilizer
until it flows into the carburetor.
WARNING: Do not keep the product with
fuel in the tank in an indoor location or in
locations with bad airflow. Risk of fire if fuel
fumes come near open flames, sparks, or
pilot lights in for example boilers, hot water
tanks and clothes dryers.
To clean the product on page
Tire pressure on
To get a good result on page
807 - 001 - 13.06.2018
To