Table of Contents
Advertisement
6. Press the
icon (fig. 6);
7. The message "Confirm?" is now displayed;
8. Press the
icon to confirm the selection;
9. "HOT WATER Press OK" is displayed;
10. Press the
icon to confirm the selection. The appliance
begins hot water delivery and the message "Please wait" is
displayed;
11. After the flow of hot water stops, the appliance automatically
resets to "Ready for coffee" status.
The new filter is now active and you can use the coffee machine.
Removing the filter
If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Remove the tank, remove the filter and put the tank back
in the appliance;
2. Press the
(B2) icon to enter the menu;
3. Press
or
displayed;
4. Press the
icon (fig. 6);
5. "Disable?" is displayed;
6. Press the
icon to confirm and the
the menu.
DISPLAYED MESSAGES
DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A13) is full.
INSERADD PRE-GROUND
COFFEE
ADD PRE-GROUND COFFEE
(fig. 5) until "Install filter Enable" is
icon to exit
POSSIBLE CAUSE
Insufficient water in the tank (A18).
After cleaning, the grounds container has not
been replaced (A13).
With the "pre-ground coffee" function selected,
pre-ground coffee has not been poured into the
funnel (A4).
TECHNICAL DATA
Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Size: LxDxH:
Cord length:
Weight:
Max. beans container capacity:
The appliance complies with the following EC
directives:
•
Low Voltage Directive 2006/95/EC and subsequent
amendments;
•
EMC Directive 2004/108/EC and subsequent amendments;
•
European Standby Regulation 1275/2008
•
Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
SOLUTION
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coffees,
the grounds container may fill up more than
expected and clog the machine.
Remove the drip tray and insert the grounds
container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 16).
21
220-240 V~ 50/60 Hz max. 10A
1450W
1,5MPa (15 bar)
1,4 l
195x480x340 mm
1660 mm
9,7 kg
200 g
Advertisement
Table of Contents
Troubleshooting
