Electrical Requirements - DeLonghi ETAM29.666.S Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

The milk contains large bubbles and
squirts out of the milk spout or there
is little froth.

ELECTRICAL REQUIREMENTS

Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you
are in any doubt about your supply contact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.
Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the proce-
dure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children
might find it and plug it into a supply socket - with the obvious consequent danger.
Please note: We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use.
IMPORTANT: The wires in the mains lead fitted to this appliance are coloured in accordance with the following code:
GREEN AND YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
-
The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or
by the earth symbol
-
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
-
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains
lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should
only be replaced with a flexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a
replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse
recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
The milk is not cold enough or is not
semi-skimmed.
The froth adjustment dial is incorrectly
adjusted.
The milk container lid or froth
adjustment dial are dirty
The hot water/steam connection noz-
zle is dirty
EARTH
NEUTRAL
LIVE
or coloured green or green and yellow.
Warning - this appliance must be earthed
Use skimmed or semi-skimmed milk at refrige-
rator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in the section
"Making cappuccinos and milk based coffees"
(page 15).
Clean the milk container lid and control knob as
described in the section "Cleaning the milk con-
tainer" (page 18).
Clean the connection nozzle as described in
the section "Cleaning the hot water/steam
connection nozzle" (page 18).
Green and Yellow to Earth
Blue to
neutral
24
13 amp Fuse
Brown to live
Cord Clamp

Advertisement

Table of Contents
loading

This manual is also suitable for:

Etam29.66 seriesEtam29.660.sbEtam29.666.t

Table of Contents