Stand; Removing The Stand - Dell W29C Service Manual

NOTE: Dell provides a list of components and their part numbers for the original system configuration purchased. These
parts are available according to warranty coverages purchased by the customer. Contact your Dell sales representative for
purchase options.

Stand

Removing the stand

Prerequisites
Follow the procedure in Before working inside your
CAUTION: When servicing the computer, place it on an elevated, clean, and flat surface. Place the display flat
on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid accidental
damage to the computer display when servicing.
NOTE: The following procedure is applicable for both Y stand and Isosceles stand.
NOTE: For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and
you must replace both of these components together. Refer to the procedure for
the display hinges.
About this task
The following image indicates the location of the stand and provides a visual representation of the removal procedure.
computer.
removing the display hinges
Removing and installing components
and installing
13