Table of Contents
Advertisement
Steps
1. Align the screw holes on the bottom cover with the screw holes on the display-assembly base.
2. Replace the five screws (M3x5) that secure the bottom cover to the display-assembly base and snap the bottom cover back
into place.
Next steps
1. Install the
back
cover.
2. Follow the procedure in
Stand
Removing the stand
Prerequisites
1. Follow the procedure in
CAUTION:
When servicing the computer, place it on an elevated, clean and flat surface. Place the display
flat on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid
accidental damage to the computer display during servicing.
2. Remove the
back
cover.
3. Remove the
bottom
cover.
About this task
The following image indicates the location of the stand and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
15
Advertisement
Table of Contents
