Table of Contents
Advertisement
15
COOLING SYSTEM
15.1
Cooling system
15.2
Checking the antifreeze and coolant level
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of chil-
dren.
Water pump
The pressure resulting from the warming of the cooling system is regulated by a valve in
radiator cap
ature will not result in a risk of malfunctions.
120 °C (248 °F)
Cooling is effected by the air stream.
The lower the speed, the less the cooling effect. Dirty cooling fins also reduce the cooling
effect.
S00469-10
Condition
The engine is cold.
–
Stand the motorcycle upright on a horizontal surface.
–
Remove the radiator cap.
–
Check the antifreeze of the coolant.
−25... −45 °C (−13... −49 °F)
»
If the antifreeze of the coolant does not meet specifications:
–
Correct the antifreeze of the coolant.
–
Check the coolant level in the radiator.
400243-10
Coolant level
»
If the coolant level does not meet specifications:
–
Correct the coolant level.
Alternative 1
Alternative 2
–
Mount the radiator cap.
in the engine circulates the coolant.
. This ensures that operating the vehicle at the specified coolant temper-
above radiator fins.
Coolant (
p. 93)
Coolant (mixed ready to use) (
10 mm (0.39 in)
p. 93)
73
Advertisement
Table of Contents
