Channel A /B Instant Call; Storing New Channel A/B; Changing The Stored Channel A/B; Operating The Channel A/B - Standard Horizon SPECTRUM + GX2355S Owner's Manual

BUSY HI USA
T/W CH16
VTS
4. To stop scanning, press the SCAN, 16/9, WX, or PTT key.
Triple watch (T/W) means the radio is watching CH70 for DSC Calls.
Dual watch (D/W) means the radio is not watching CH70 for DSC Calls.

5.10 CHANNEL A /B INSTANT CALL

Two calling channels (used by an organization or a favorite channel)
can be preset. But USA channels 9 and 16, and WX channels should
not be assigned as A or B channels because they are readily available
with the 16/9 and WX keys. If the A/B key is pressed and no channel A
or B has been assigned, the alert signal will be present.

5.10.1 Storing new channel A/B

1. Press and hold down the A/B key and rotate the Channel Selector
knob to select the desired channel.
2. Release the A/B key to store a desired channel as channel A/B.
3. Repeat steps to program second channel A/B.

5.10.2 Changing the stored channel A/B

1. Press the A/B key for memorized channel to appear.
2. Press and hold down the A/B key and rotate the Channel Selector
knob to select the desired channel.
3. Release the A/B key to store a desired channel as channel A/B.
The stored channels will delete in microprocessor resetting mode only.

5.10.3 Operating the channel A/B

Pressing the A/B key more than once toggles between channel A,
channel B and the channel that was received on.

5.11. PA/FOG OPERATION

PA HAIL mode:
PA HAIL mode allows the transceiver to be used as a power hailer when an
optional 4 ohm hailer speaker is installed. The Hail mode has a listen-back
feature which provides two way communication through the hailer speaker.
GX2355S
3. The scanning will be performed while receiving
the MEM CH (memorized channel).
A
NOTE
NOTE
Owner's Manual page 17