Memory Scanning (M-Scan); Priority Scanning (P-Scan) - Standard Horizon SPECTRUM + GX2355S Owner's Manual

5.8 MEMORY SCANNING (M-SCAN)

• During scanning, the dot matrix area of the LCD will show M-SCAN or
P-SCAN depending on the scan mode selected.
• The channel numbers programmed will cycle on the LCD.
• If position is displayed this icon will be hidden.
1. Adjust the SQL knob until background noise disappears.
2. Select a desired channel to be scanned using the Channel
Selector knob. Press the MEM key, MEM will appear on the LCD
which indicates the channel has been programmed into the
transceivers memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver's memory, press the
MEM key, MEM will disappear in the LCD.
5. To start scanning, press the SCAN key. Scanning will proceed from
the lowest to the highest programmed channel number and will stop
on a channel when a transmission is received.
BUSY HI USA
M–SCAN
VTS
7. To stop scanning, press the SCAN, 16/9, WX, or PTT key.

5.9 PRIORITY SCANNING (P-SCAN)

1. Any channel can be set as the priority channel, other than weather
channels and channel 70. To set the priority channel, select the
desired channel. Press and hold down the MEM key until P-CH is
shown on the display.
MEM HI USA
P–SCAN CH16
MEM CH.
page 16
6. The channel number will blink during reception.
A
2. To select priority scanning, hold down the
SCAN key until P-SCAN appears on the LCD
during memory scanning. Scanning will proceed
A
between the memorized channels and the
priority channel. The priority channel will be
scanned after each programmed channel.
P-CH. CH. 70
(When DSC scaning
is available)
Owner's Manual
NOTE
MEM CH. P-CH. CH. 70
(When DSC scaning
is available)
GX2355S