Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery; Installing/Changing The Saw Blade - Parkside PSTDA 20-Li B3 Translation Of The Original Instructions

GB CY
Only insert the battery once
the battery-operated tool is
fully ready for use.
Checking the
charge status of the
rechargeable battery
The battery charge status indicator (22a)
signalises the state of charge of the battery
(22).
Press the button on the battery charge sta-
tus indicator (22a). The state of charge of
the battery is displayed by illuminating the
3-colour LED lights of the state of charge
display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (22) when
the red LED on the charge status
indicator (22a) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (22) when
the red LED on the charge status
indicator is on.
PLG 20 A1 PLG 20 A3
Charging
time (min.)
PAP 20 A1
PAP 20 A3
120
12
PDSLG 20 A1
60 30
60
1. Remove the battery (22) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (22) in the charging
compartment of the battery charger
(24).
3. Plug the battery charger (24) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (24) from the
mains.
5. Remove the battery (22) from the
charger (24).
Installing/changing the
saw blade
Wear protective gloves when
attaching the saw blade.
Risk of injury when touching the
saw blade.
Only saw blades with a
T-shank mount (single lug
shank) such as the supplied
saw blades (16/17) can be
used.
Installing the saw blade
Make sure that the saw blade holder is
free of splinters or other material residue.
1. Turn the clamping lever (28) as far to
the left as possible and hold it fi rmly in
this position.
2. Insert the saw blade (16/17) into the
chuck (10). When inserting the saw
blade (16/17), make sure that the
back of the saw blade is in the notch
of the guide roller (9). Make sure that
the saw blade (16/17) is attached cor-
rectly and the teeth are pointing in the
cutting direction.
3. Release the clamping lever (28).