Toyota 1C Repair Manual page 68

EM -62
ENGINE MECHANICAL - Cylinder Head
(Q)
Cut Position
l'J t,
REPLACEMENT OF CAMSHAFT Oil SEAL
NOTE: . There are two ways of oil seal replacement
depending on whether the oil seal retainer was removed or
not.
1. IF OIL SEAL RETAINER WAS REMOVED FROM
CYLINDER HEAD
(a)
Using a screwdriver and hammer, drive out the oil
seal.
(b) Apply MP grease to the oil seal
(c)
Using SST and a hammer, drive in a new oil seal until
its
surface is flush with the oil seal retainer edge.
SST
09214-60010
2.
IF OIL SEAL RETAINER WAS NOT REMO VED FROM
CYLINDER HEAD
(a)
Using a knife, cut ott the oil seal lip.
(b) Using a screwdriver. pry out the oil seal
CAUTION: Tape the screwdriver tip and be careful
not to d amage the camshaft.
(c) Apply MP grease to a new oil seal
(d) Using SST and a hammer. drive in the oil seal until its
surface is flush with oil seal retainer edge.
SST
09214-60010