Hard Disk Drive - IBM Aptiva 2190 Hardware Maintenance Service

Hard Disk Drive

To remove or replace the hard disk drive:
q
Make sure to disconnect the power and signal cables from the CD-ROM
drive and the diskette drive.
q
Remove the four screws that secure the bay holder to the metal frame of
the system unit.
q Rotate the rear of the Hard Disk Drive bay holder upward about sixty
degrees to disconnect the signal and power cables from the hard disk.
q Lift the Hard Disk Drive bay holder upward to completely remove from the
system unit.
q Turn the Hard Disk Drive bay holder upside down and place on
worksurface.
q
Remove the four screws that secure the hard disk to the Hard Disk Drive
bay holder.
4-10