Table of Contents
Advertisement
inFormAtion
Displayingsignalinformation
(for digital channels only)
1 Open the menu with
»
2 Select the line
SOURCE SETUP
»D«
or
and press
»
3 Select the line
Signal Information
»C«
»D«
or
and press
– I nformation on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
notes:
T he signal information changes in ac c ord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
»
bars for
Quality
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
»m«
4 Press
to close the menu.
---------------------------------------------------------------------------------------------------------------------
»m«
.
«
»C«
with
»
«
oK
to confirm.
«
with
»
«
oK
to confirm.
«
»
and
Signal Strenght
«
5 5
ENGLISH
Advertisement
Table of Contents
