Displaying Signal Information - Grundig 50 VLE 930 BL Manual

inFormAtion
Displaying­signal­information
(for digital channels only)
1 Open the menu with »menu«.
2 Select the line »SOURCE SETUP« with »
or » « and press »oK« to confirm.
Λ
3 Select the line »Signal Information« with
» « or » « and press »oK« to confirm.
v Λ
– I nformation on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
notes:
T he signal information changes in ac c ord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4 Press »menu« to close the menu.
­---------------------------------------------------------------------------------------------------------------------
«
v
­ 6 9
ENGLISH