Displaying Signal Information; Pre-Programming The Remote Control For Other Grundig Devices - Grundig 40 VLE 6120 BF Manual

INFormAtIoN
Displaying­signal­information
(for digital channels only)
1 Open the menu with »i«.
2 Select the line »SOURCE SETUP« with »
or » « and press »●« to confirm.
Λ
3 Select the line »Signal Information« with
» « or » « and press »●« to confirm.
v Λ
– I nformation on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
T he signal information changes in ac c ord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
i
4 Press » « to close the menu.
­---------------------------------------------------------------------------------------------------------------------
pre-programming­the­remote­
control­for­other­GruNDIG­
devices
«
v
Changing­the­pre-programming­­
of­the­remote­control
1 Press and hold »m« and simultaneously
»DVB« has been pre-programmed for op e r-
7
ating a GRUNDIG digital receiver (remote
control level 1).
»DVD« has been pre-programmed for oper-
7
ating a GRUNDIG DVD player.
»AMP« has been pre-programmed for oper-
7
ating a GRUNDIG AV receiver.
The functions available depend on the model
7
of the device you are using. Just try it out.
enter the three numbers of the corre s ponding
code:
»1«, »2«, »3« for a GRUNDIG DVD player.
»4«, »5«, »6« for a GRUNDIG DVD recorder.
» 1«, »4«, »7« for a GRUNDIG digital
receiver (remote control level 1).
» 2«, »5«, »8« for a GRUNDIG digital
receiver (remote control level 2).
» 3«, »6«, »9« for a GRUNDIG digital
receiver with a hard disk (PDR).
­ 4 9
ENGLISH