Cleaning; Washing The Underside Of The Mower - Toro 75201 Operator's Manual

Figure 67
1. Spring-removal tool (Toro
Part No. 92-5771)
2. Idler spring
3. Deck post
8. Lower the mower to the lowest height of cut and
place the height-of-cut pin in the lock position for
the lowest height-of-cut.
9. Remove the belt from the mower-deck pulleys
and remove the existing belt.
10. Install the new belt around the mower pulleys
and the clutch pulley under the engine
67).
WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
11. Using a spring-removal tool, (Toro Part No.
92-5771), install the idler spring over the deck
post and placing tension on the idler pulley and
mower belt (Figure
12. Ensure that the belt is properly seated in all
pulleys.
13. To install the belt covers, insert the tabs on the
each cover into the corresponding slots on the
deck bracket, ensuring that they seat.
14. Rotate the cover to the deck and slide the
notches under the loosened bolts until they are
seated.
15. Tighten the bolts to secure the cover to the deck.
4. Idler arm
5. Mower belt
(Figure
67).

Cleaning

Washing the Underside of
the Mower
Service Interval: After each use—Clean the
Important:
You can wash the machine with a mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
Wash the underside of the mower deck after each use
to prevent grass buildup for improved mulch action
g028279 and clipping dispersal.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Attach the hose coupling to the end of the
mower washout fitting, and turn the water on
high (Figure
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
1. Washout fitting locations
on 54-inch decks
2. Washout fitting locations
on 48-inch decks
3. Washout fitting
4. Lower the mower to the lowest height of cut.
45
mower-deck housing.
68).
Figure 68
4. O-ring
5. Hose
g017966