Installing The Mower Deck; Replacing The Grass Deflector - Toro 75201 Operator's Manual

Installing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Place the height-of-cut pin in the lock position
for lowest height of cut.
6. Lift the rear of the mower deck and attach the
chains to the rear lift arms
7. Attach the front chains to the front lift arms
(Figure 64).
8. Install the long link bar through the frame hanger
and deck.
9. Secure the link pin with the hairpin cotters and
washers removed previously
10. Install the mower belt onto the engine pulley;
refer to Replacing the Mower Belt (page
(Figure 64).
(Figure 63).
44).
43
Replacing the Grass
Deflector
Service Interval: Before each use or daily—Inspect
the grass deflector for damage.
WARNING
An uncovered discharge opening could allow
the lawn mower to throw objects toward you
or bystanders, resulting in serious injury.
Also, contact with the blade could occur.
Never operate the machine without the
grass deflector, the discharge cover, or the
grass-collection system in place.
Never operate the machine without the
grass deflector, the discharge cover, or the
grass-collection system in place.
1. Disengage the spring from the notch in the
deflector bracket and slide the rod out of the
welded deck brackets, spring, and discharge
deflector (Figure
Figure 65
1. Rod
2. Spring
3. Deflector
2. Remove the damaged or worn discharge
deflector.
3. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
65).
4. Deck brackets
5. Spring installed over the
rod
Figure 66.
g197127