Rinsing; Over Flow Rinse; Additional Rinse - Samsung DC68-02206A-01 Owner's Instructions Manual

RINSING

1. Set the CYCLE SELECTOR KNOB to 'WASH RINSE' .
(In case no drain pump) ('WASH' in case drain pump)
(Without pump)
2. Supply the proper amount of water as not to
overflow the top of the washing tub.

OVER FLOW RINSE

1. Keep suppling water
Adjust water pressure to ensure that the
amount of water supplied does not exceed
that water drained.
(Without pump)
2. Set the WASH TIMER 6~8
minutes.

ADDITIONAL RINSE

After rinsing you can select this course for more effective rinse (Don't select only this course for rinse.)
1
Load the laundry evenly into the
spin basket.
2
Set the WATER SELECTOR
KNOB to SPIN (a) and
CYCLE SELECTOR KNOB
to 'DRAIN'(b).
3
Supply water for about 1
minute. Adjust the water
flow to prevent overflow
from the wash tub.
WT80J7-02206A_EN.indd 5
All manuals and user guides at all-guides.com
(With pump)
(With pump)
(b)
(a)
1min.
5
3. Set the WASH TIMER 2~3minutes.
4. Drain the water. Set the CYCLE SELECTOR KNOB
to 'DRAIN'
5. Repeat this cycle until drain water is clean. (2~3
cycles)
6. In case no drain pump.
- Be sure lay the drain hose down.
In case drain pump.
- Be sure place the drain hose in sink or bath.
3. As soon as the WASH TIMER shuts off, turn off the
water tap.
4. Set the CYCLE SELECTOR
KNOB to 'DRAIN' .
inner lid
safety cover
5
6
4
After stopping water
supply, cover the
laundry with safety
cover and close the
inner lid.
Close the spin dryer lid.
Set the AIR TURBO SPIN
TIMER 2~3 minutes.
2006-02-17 ¿ÀÈÄ 2:43:24