Table of Contents
Advertisement
4. Set the AIR TURBO SPIN
TIMER 1-10 minutes.
5. Incomplete spining.(Severe vibration or
unbalance) See "When you load ..."on page 6.
Rinsing
1. Set the CYCLE SELECTOR KNOB to 'WASH RINSE'.
Without pump
2. Supply the proper amount of water as not to
overflow the top of the washing tub.
3. Set the WASH TIMER 2~3
minutes.
4. Drain the
water.Set
the CYCLE
SELECTOR
KNOB to
'DRAIN'.
Without pump
5. Repeat this cycle until drain water is clean. (2~3 cycles)
6. Place your drain hose;
- In case no drain pump: Be sure lay the drain
hose down.
- In case drain pump: Be sure place the drain
hose in sink or bath.
Over flow rinse
1. Keep suppling water.
Adjust water pressure to ensure that the amount of
water supplied does not exceed that water drained.
Without pump
2. Set the WASH TIMER 6~8
minutes.
8_ washing procedure
WT16J8PEC_DC68-03040B-07_EN.indd 8
With pump
With pump
With pump
3. As soon as the
WASH TIMER shuts
off, turn off the water
tap.
4. Set the CYCLE
SELECTOR
KNOB to
'DRAIN'.
Without pump
Additional rinse
After rinsing you can select this course for more
effective rinse (Don't select only this course for rinse.)
1. Load the laundry evenly into the spin
basket.
2. Set the
(a)
WATER
SELECTOR
KNOB to
SPIN (a)
and CYCLE
SELECTOR
KNOB to
Without pump
'DRAIN (b)'.
3. Supply water for about 1minute.
Adjust the water flow to prevent
averflow from the wash tub.
4. After stopping water
Inner lid
supply, cover the laundry
with safety cover and
Safety
close the inner lid.
cover
5. Close the spin dryer lid.
6. Set the AIR TURBO SPIN
TIMER 2~3 minutes.
With pump
(b)
With pump
1min.
3/26/2020 8:02:59 PM
Advertisement
Table of Contents
