Programming; Using The Learn Button; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory - Craftsman 315 SERIES 139.53939D Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote
that you wish to operate your garage
door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the purple "learn" button on
motor unit until the learn indicator light goes
out (approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical measure in

To Add or Reprogram a Hand-held Remote Control

*

USING THE MOTION DETECTING CONTROL CONSOLE

1. Press the Learn button on the Motion
Detecting Control Console.
2. Press the Learn button again to confirm
Learn Mode.
3. Press the button on the hand-held
remote * that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.

*3-Function Remotes

If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
®
any Security✚ 3-Function
remote or compact remote
can be programmed to
operate other Security✚
garage door openers.
37
® remote controls.
®