Lcd Motion Detecting Control Console Messages - Craftsman 315 SERIES 139.53939D Owner's Manual

LCD Motion Detecting Control
Console Messages
The following messages are contained within the LCD
Motion Detecting Control Console and may appear
during the operations of the unit:
Message
SAFETY SENSORS
CHECK ALIGNMENT,
BLOCKAGE OR
MISWIRING SEE
OWNER'S MANUAL
Message
SAFETY SENSORS
MALFUNCTION
CHECK MISWIRING
SEE OWNER'S
MANUAL
Message
LEARN REMOTE
CONTROL PRESS
LEARN BUTTON
TO CONFIRM
Message
LEARN MODE PRESS
REMOTE CONTROL
BUTTON TO
PROGRAM REMOTE
Message
LOCK MODE REMOTE
CONTROL LOCKED
OUT PRESS LOCK
BUTTON TO ENABLE
REMOTE
Message
ENGLISH, FRANÇAIS
AND ESPAÑOL
Message
MOTION SENSING ON
MOTION SENSING
OFF
Meaning: This message will appear if the Safety Reversing Sensors are out of
alignment, if they are blocked or if the wiring is disconnected. To clear message from
Control Console do the following:
• Check to see that area is clear between the Safety Reversing Sensors.
• Check to see that the Safety Reversing Sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is firmly secured to wall and does not move.
• Check to see that the Safety Reversing Sensors' wires are connected to the motor unit.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message will appear if the Safety Reversing Sensors are miswired.
To clear the message, do the following:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct wiring
polarity (black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of motor unit.
• Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 ft.
(30-60 cm) from back of each sensor.
• Reattach sending eye to motor unit using shortened wires. If sending eye indicator light
glows steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors. If the sensor
indicator lights do not light, replace the safety reversing sensors.
Meaning: This message will appear when the 'LEARN' button has been pressed on
the Control Console. Pressing the 'LEARN' button again will allow the user to
program an additional remote control to the opener.
Meaning: This message will appear when the 'LEARN' button has been pressed a
second time on the Control Console or anytime on the opener. The opener
is ready to program another remote control by simply pressing the remote control
button. Once the opener has 'LEARNED' the remote control, the worklight will blink
one time.
Meaning: This message will appear when the 'LOCK' button has been pressed and
held for more than one second. This feature will disable the opener from receiving
remote control signals. To exit 'LOCK' mode, press and hold the button
for more than one second.
Meaning: This message will appear when the 'LANGUAGE' button has been pressed.
Pressing the button will toggle to the next language.
Meaning: This message will appear when the Motion Sensing button is pressed. The
motion detector will toggle on or off with each press of the button.
36