Microsoft XBOX CONTROLLER Repair Instructions page 40

4. Install Palm Motors
Gently press each palm rumble motor into the mid-frame. A plastic pry tool may be
required to gently bend the retention clip back.
NOTE: The motors are soldered to the main board. This solder connection is very
fragile at both the motor and board ends. Take care not to damage the soldered
connection.
5. Route Wires
Once the motors are back in place, route trigger motor wires through the side clip, and
through the mid-frame retention tabs up to the triggers.
IMPORTANT:
wire route to ensure wire length at the triggers is short enough to not be pinched
at a later step.
Leave about 1 in. (25mm) of wire on the mainboard portion of the
39