Ericsson R320s User Manual page 9

Charging the Battery
1. Make sure that the battery is
attached to the phone.
2. Connect the charger to the mains.
Note! The mains plug may look different depending on the mains socket in
your country. Do not connect it to any other item than your Ericsson Travel
Charger CTR-10. It must not be separated from the charger when plugged
into the mains socket.
To indicate charging:
• the battery meter in the display pulses continuously
• the indicator on top of the phone shows a steady red light (or green, if the
phone is switched on)
• the message
Optimized Charging
Ericsson-approved battery)
Note! If you charge a new battery that is empty, or a battery that has not been
used for a long time, it may take several minutes until you get an indication of
charging in the display. Only then can you switch on and use your phone.
When the battery is fully charged, the battery meter in the display is full and
the indicator on top of the phone shows a steady green light.
Tip! You can use the phone while the battery is being charged. However, this
lengthens the charging time.
An Ericsson-approved battery is indicated by
start charging the battery. For the best charging, talk and standby times in the
long run, we recommend that you use only Ericsson-approved batteries with
your phone.
3. Connect the charger to the phone
as shown in the picture. The flash
symbol on the plug must face
upwards.
is shown briefly in the display (with an
Optimized Charging
Preparing Your Phone for Use
each time you
9