Husqvarna VITPILEN 401 2020 Owner's Manual page 168

14 WHEELS, TIRES
166
–
Clean the thread of the wheel spindle and screw
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel
speed sensor
–
Position the fender, and mount and tighten screws
the washers.
E01130-11
Guideline
Screw, fender on
axle clamp
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
p. 258)
2
.
M8 20 Nm (14.8 lbf ft)
3
in the hole.
4
.
M6 7 Nm (5.2 lbf ft)
Loctite
M6 12 Nm (8.9 lbf ft)
2
.
® 243™
5
with