Table of Contents
Advertisement
6.5
Electronic Controller
6.5.1
Remove the drawer front and handle as per instructions in 6.1 & 6.2.
6.5.2
Placing a finger either side of the top sides of the controller, pull it forward until the
controller clears the top edge of the tub.
6.5.3
Disconnect the wiring connectors down the left side of the controller.
6.5.4
The controller can now be tipped down to 90° from it's original position. This will
allow the disconnection off the lower wiring connectors and the two and three wire
looms from their wire duct.
6.5.6
The controller can now be lifted clear.
6.5.7
Refit in reverse manner.
6.6
Top Kick Strip Removal
6.6.1
Pull out the lower drawer.
6.6.2
Place both hands under the top kick strip.
6.6.3
Pull the bottom of the top kickstrip forward quickly.
6.6.4
Tipping it right up will allow the top locating tabs to drop out of the tub inserts.
6.6.5
Refit in reverse manner ensuring it is clipped into place.
6.7
Lower Kick Strip Removal
6.7.1
Remove the top kick strip as per instructions in 6.6.
6.7.2
Insert a flat blade screwdriver into the two inserts in the trim above the lower kick
strip and twist.
6.7.3
This will unclip the lower kick strip from the chassis.
6.7.4
Refit by locating the lower kick strip pins into the chassis clips and foot retainer
clips.
6.7.5
Push on the face of the lower kick strip to locate home the lower kickstrip pins.
- 40 -
Advertisement
Table of Contents
