A Configuring The Hba; Starting The Configuration Protocol; Using The Driver Configuration Menu - HP StorageWorks A6826A Installation Manual

A Configuring the HBA
This appendix describes how to configure the A6826A HBA on Linux systems using the
Configuration protocol Driver Configuration menu.
NOTE: This process is for advanced users who want to customize the configuration of the
A6826A HBA and the connected devices.
This appendix includes:
• Starting the Configuration
• Using the Driver Configuration

Starting the Configuration protocol

To configure the HBA on Linux, access the Configuration protocol as follows:
1. Use the fibreutils RPM package to obtain efiutil (efiutil.efi) and the auxiliary driver,
efiaux.drv as described in
2. Power-on the server to the EFI shell.
3. Start efiutil as follows (efiaux.drv is automatically loaded if it is needed):
a. Set the drive to the boot device (for example, fs1:).
b. Change to the directory containing efiutil. For example, enter:
cd efi\qla2300
c. Run efiutil:
efiutil.efi
Enter help at any time for information about commands.
d. Select the HBA channel that you want to configure by selecting adapter.
e. Select configure.
4. Configure the HBA's NVRAM by selecting the menu items for the parameters to be changed .
5. Write the new configuration to NVRAM.
6. Exit the utility (select quit).
7. Reboot the system.

Using the Driver Configuration menu

This section describes the Configuration protocol's Driver Configuration menu. The menu contains
the following sections and functions:
• NVRAM—Modify settings that are stored in the HBA's NVRAM.
• Information—View device, HBA, and Help information.
• Operation—Write or discard NVRAM data and exit the Configuration protocol.
protocol, page 27
menu, page 27
"Installing the fibreutils
A6826A PCI-X host bus adapter for Itanium Linux systems installation guide
Get other manuals https://www.bkmanuals.com
RPM" on page 21.
27