Using Fibreutils Rpm; Changing Driver Parameters; Installing The Driver On The Boot Drive - HP StorageWorks A6826A Installation Manual

Pci-x host bus adapter for itanium linux systems

Hide thumbs Also See for StorageWorks A6826A:

Table of Contents

Using fibreutils RPM

HP recommends using the fibreutils utility that is installed by the driver kit. It contains useful utilities

for managing fibre-attached storage. To manually install this RPM, enter the following command:

# rpm -ivh fibreutils-<version>.rpm

For more information about fibreutils, see the file /opt/hp/hp_fibreutils/README.

To change driver parameters:

Run the set_parm script located in the /opt/hp/src... directory.

Reboot the system.

NOTE:

You may not be able to unload the qla2200 and/or qla2300 modules if there is a process

or file system using a device that is attached to the A6826A HBA.

NOTE:

The following instructions for installing the driver and loading and unloading the driver are

required only if the driver has been built from source. If the driver was installed from an RPM or

driver kit, the driver loads at boot time.

Before installing the driver, note the following:

•

The A6826A HBA must be installed in the system before installing the qla2300 driver.

•

The <kernel_release_version> is the Linux kernel release version of your system.

•

In the following example, the path to your driver may be:

/lib/modules/<kernel_release_version>/kernel/drivers/addon/...

A6826A PCI-X host bus adapter for Itanium Linux systems installation guide

Get other manuals https://www.bkmanuals.com

Table of Contents