Table of Contents
Advertisement
Wiring the Mains Power Supply Plug (UK Only)
IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug
incorporating a fuse. The value of the fuse is indicated on the pin face
of the plug and, if it requires replacing, a fuse approved to BSl1362 of
the same rating must
be
used.
Never use the plug with the fuse cover omitted if the cover is
detachable. If a replacement fuse cover is required, it must
be
of
the same colour as the pin face of the plug. Replacement covers are
available from your dealer.
If the fitted plug is not suitable for the power points in your house or
the cable is not long enough to reach a power point, you should obtain
a suitable safety approved extension lead or consult your dealer for
assistance. However, if there is no alternative but to cut off the plug,
remove the fuse and then safely dispose of the plug.
Do NOT connect the plug to a mains socket as there is a risk of shock
hazard from the bared flexible cord.
IMPORTANT
Thew1res In the mains lead are coloured in accordance with the
following code:
BLUE
-
NEUTRAL BROWN LIVE
As these colours may not correspond to the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire coloured BLUE must
be
connected to the terminal marked
with the letter N or coloured BLUE or BLACK. The wire coloured
BROWN must be connected to the terminal marked with the letter L
or coloured BROWN or RED.
A
WARNING
DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH
IS MARKED WITH THE LETTER E OR BY THE EARTH SYMBOL, OR
COLOURED GREEN OR GREEN AND YELLOW
Regulatory Compliance Statements
USA
FCC Supplier's Declaration of Conformity
Responsible Party- U.S. Contact Information:
Samsung Electronics America, Inc.
85 Challenger Road.
Ridgefield Park, NJ 07660
Phone: 1-800-SAMSUNG (726-7864)
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules.
Operation is subJect to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.
Class B FCC Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment.
This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter
A
WARNING
User must use shielded signal interface cables to maintain FCC
compliance for the product
Advertisement
Table of Contents
