Programmable Memory Scan (Pms); Registering To The Programmable Memory Channels - Yaesu FTM-7250DE Advance Manual

Scanning

Programmable Memory Scan (PMS)

The FTM-7250DR/DE can be set to tune or scan only the frequencies between user-
defined lower and band limits.
Example: Set up a PMS channel by registering a lower frequency of 432.500 MHz, and
an upper frequency of 432.800 MHz to the L1/U1 memory channels.

Registering to the programmable memory channels

1. In the VFO mode, select the desired lower-limit scan frequency (432.500 MHz).
2. Press and hold the [ V/M ( MW )] key.
A memory number will appear in the bottom right
corner of the display.
3. Rotate the DIAL knob to select "L1".
Note: While operating in the Memory Storage mode, the keypad of the MH-48A6JA
Microphone may be used to enter the memory channel number directly.
To do this, enter the desired Channel Number (see table below) on the keypad.
To enter Memory Channel "L1", press [ 2 ] à [ 0 ] à [ 1 ]
To enter Memory Channel "U0", press [ 2 ] à [ 2 ] à [ 0 ]
L1
U1
L2
U2
4. Press the [ V/M ( MW )] key again, momentarily, to store the displayed data into the mem-
ory channel (L1).
5. Select the desired upper-limit scanning frequency (432.800 MHz).
6. Rotate the DIAL knob to select "U1".
7. Press the [ V/M ( MW )] key again, momentarily, to
store the displayed data into the memory channel
(U1).
201 L3 205
202 U3 206
203 L4 207
204 U4 208
L5 209 L7
U5 210 U7
L6 211 L8
U6 212 U8
22
213 L9 217
214 U9 218
215 L0 219
216 U0 220