Table of Contents
Advertisement
1
Push-Button Switch SW2
© National Instruments Corporation
As an alternative method, complete the following steps:
1.
Power off the chassis.
2.
Remove the controller from the chassis.
3.
Press and hold down push-button switch SW2 for 2 to 3 seconds.
The switch location is shown in Figure 5-1.
4.
Reinstall the controller in the chassis.
Figure 5-1. Clearing the CMOS Contents
1
5-3
Chapter 5
Troubleshooting
NI PXI-8108 User Manual
Advertisement
Table of Contents
