National Instruments NI PXI-8108 User Manual page 18

Chapter 2 Installation and Configuration
1 Protective Screw Cap (4X)
Caution Do not raise the injector/ejector handle as you insert the NI PXI-8108.
The module will not insert properly unless the handle is in its downward position
so that it does not interfere with the injector rail on the chassis.
NI PXI-8108 User Manual
4. Remove the protective plastic covers from the four bracket-retaining
screws as shown in Figure 2-1.
Figure 2-1. Removing Protective Screw Caps
5. Make sure the injector/ejector handle is in its downward position.
Align the NI PXI-8108 with the card guides on the top and bottom
of the system controller slot.
1
2-2 ni.com