Table of Contents
Advertisement
a.
Select Window»Show Block Diagram to open the VI block diagram.
b.
On the block diagram, right-click the Open FPGA VI Reference (NI PXI-7952R) function and
select Configure Open FPGA VI Reference.
c.
In the Configure Open FPGA VI Reference window, click the Browse Project button in the
Open VI section.
d.
In the Select VI window that opens, expand the tree view for your device, select the VI under
your device and click OK.
e.
Click OK in the Configure Open FPGA VI Reference window.
f.
Save the VI.
6.
On the front panel, select appropriate values in the Num Samples, Generation Mode, Generation
Constant, and DDC A Voltage Level controls.
7.
Click the Run button to run the VI. The NI 6583R generates a waveform on the even channels of
your device and then acquires that waveform on the odd channels of your device. The front panel
of the host VI displays both the generated and acquired waveforms, as shown in Figure 13. Use the
DDC A and DDC B tabs on the left side of the front panel to toggle between connectors. If the
generated and acquired waveforms match, then the DDC x Verified? indicator illuminates.
8.
Close the VI.
NI 6583R User Guide and Specifications
Figure 13. NI 6583 Acquisition and Generation Simple (Host) VI Front Panel
18
ni.com
Advertisement
Table of Contents
