National Instruments NI 6583R User Manual And Specifications page 17

A flying lead cable, the NI SHB12X-H3X24, is also available for differential signals. This cable offers
connectivity similar to that found on a typical logic analyzer, so you can use it in logic analyzer-type
applications. This cable is shown in Figure 12.
1 Leads (1 × 3 Header Receptacle)
2 DDC B Connector
Creating a Custom Accessory
Many common applications may require you to create a custom accessory to easily access the signals of
your device under test (DUT). If you are creating a custom accessory to use with a device with a VHDCI
DDC connector, you can purchase the mating connector for the VHDCI cable from NI. For more
information about creating these custom accessories, refer to the Interfacing to the NI Digital Waveform
Generator/Analyzer using the VHDCI Connector application note, available by entering
text field at
ni.com/info
InfiniBand connector, you can also purchase this connector.
Note
If you design a custom cabling solution with the DDC B differential connector (779157-01)
and SHB12X-B12X shielded cable (192344-01), the NI 6583 pinout is reversed at the end connector.
For example, the signal shown on pin 1 maps to pin 73 at the end connector. Refer to
and Connector Pinouts
NI 6583R User Guide and Specifications
2
Figure 12. NI SHB12X-H3X24 Flying Lead Cable
. If you are designing a custom accessory to use with a device that uses an
section in this document for more pinout information.
16
1
3
3 Removeable Sleeving
in the
rdinwa
Front Panel
ni.com