Table of Contents
Advertisement
Engine Oil
27
Figure 21 Coat Rubber Seal
13. Tighten the oil filter by hand until tight. Do not use a band wrench or channel lock plier to tighten.
14. Lower the vehicle and remove the floor jack from under the rear of the vehicle.
15. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil into the
dipstick port (Figure 22). With filter change, the engine requires 38 ounces (1.12 liters) of oil per change. Refer to
oil viscosity guidelines for selection of oil grade (Figure 23). Replace the dipstick.
16. Connect the battery cables, positive (+) cable first, and tighten terminals to 144 in-lb (16 N·m). Coat terminals with
Battery Terminal Protector Spray (P/N 603 00 00-03).
17. Lower the cargo bed. See WARNING "For vehicles with cargo beds..." in General Warnings on page 9.
18. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for a few minutes. Observe
both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If leaks appear, begin with step
1 and repeat the appropriate step for either or both items to correct the problem.
19. Remove the dip stick and check the engine oil as a final step. Replace the dip stick.
OIL VISCOSITY
Choose the viscosity according to the temperature as indicated by the oil viscosity chart (Figure 23).
SAE 10W-30/ SAE 10W-40
SAE 5 W-30
213
Figure 23 Oil Viscosity Chart
Page 34
2008 HUV 4213-G and HUV 4213-GXP Owner's Manual
SAE 30
Get other manuals https://www.bkmanuals.com
172
Figure 22 Add Engine Oil
Advertisement
Table of Contents
