Master Cylinder - Husqvarna HUV 4213-G 2008 Owner's Manual

Master Cylinder

MASTER CYLINDER
1. Full Level 2. Safe Level 3. Low Level
168
Figure 16 Brake Fluid Reservoir
The master cylinder is located under the passenger seat toward the center of the vehicle (Figure 16). Raise or
remove the seat to check the brake fluid level.
When checking the brake fluid, also inspect the following:
• The presence of brake fluid on the exterior surface of the master cylinder indicates a leak.
• The vent holes in the reservoir cover should be clean and open.
• The reservoir diaphragm should not have holes or other damage.
BRAKE FLUID
Brake fluid level should be within 1/4-inch (6 mm) from top of reservoir (Figure 16). Also, brake fluid should be clean
with no residue in bottom of reservoir or other evidence of contamination.
CAUTION
• Use only DOT–5 (silicone) brake fluid. Use of any other type brake fluid is not recommended.
Page 30 2008 HUV 4213-G and HUV 4213-GXP Owner's Manual
1
2
3
Get other manuals https://www.bkmanuals.com