Sharp SF-2025 Service Manual page 46

7. Confirm that the staple sorter can be attached
and detached correctly.
1 Latch and unlatch the staple sorter from the copier to confirm that
it moves smoothly.
2 Confirm that the staple sorter locks into place beside the copier.
If not, adjust the height of the sorter mounting plate until the staple
sorter locks securely into place.
Soter mounting plate
8. Remove the copier's rear cabinet panel and cut
off the cut portion of the left cabinet.
Remove the 6 screws securing the copier's rear cabinet panel and
take the panel off.
Next, cut off the cut portion (1 location) of the left cabinet panel.
Mounting
screws
Rear cabinet
panel
Mounting screws
9. Attach the sorter connectors.
Loosely screw in 1 of the 2 supplied bracket screws as shown in the
figure. Hook the bracket in place over this screw, then insert the
remaining bracket screw and tighten both screws securely.
Next, connect the sorter's 6-pin and 10-pin connectors to the copier's
6-pin and 10-pin connectors. Then insert the clasp of the tie band into
the hole on the bottom of the installation board.
Bracket
mounting
screws
10-pin connector
Notch
Bracket mounting
screws
Bracket
Tie band
6-pin connector
10. Reattach the rear cabinet panel.
Reattach the rear cabinet panel in its original position with the 6
mounting screws.
Mounting
screws
Rear cabinet
panel
Mounting screws
11. Affix the stapling location labels.
Affix the stapling location labels to the copier and RADF (SF-A54) as
shown in the figure.
Copier
RADF (SF-A17/56)
5 – 16