Sharp SF-2025 Service Manual page 136

Main code Sub code
°
53 03 RADF and ADF stop position adjustment value (thin paper, single copy) setting
Used to adjust the RADF stop position in single copy with thin paper.
When this simulation is executed, the ready lamp lights up and the currently set adjustment value is
displayed. Enter the new adjustment value and press the PRINT switch to store it in the memory. The
adjustment value should be in the range of 0 to 15.
°
04 RADF and ADF stop position adjustment value (thin paper, duplex copy) setting
Used to adjust the RADF stop position in duplex copy with thin paper.
When this simulation is executed, the ready lamp lights up and the currently set adjustment value is
displayed. Enter the new adjustment value and press the PRINT switch to store it in the memory. The
adjustment value should be in the range of 0 to 15.
°
05 RADF and ADF resist sensor adjustment
Used to adjust the RADF resist sensor. (In the case of ADF, the resist sensor and the paper pass
width sensor are adjusted.)
When this simulation is executed, the RADF resist sensor is adjusted and the adjustment value is
displayed.
°
06 RADF and ADF timing sensor adjustment
Used to adjust the RADF timing sensor.
When this simulation is executed, the RADF timing sensor is adjusted and the adjustment value is
displayed.
°
07 RADF and ADF repulsion sensor adjustment
Used to adjust the RADF repulsion sensor.
When this simulation is executed, the RADF repulsion sensor is adjusted and the adjustment value is
displayed.
°
08 RADF and ADF empty sensor adjustment
Used to adjust the RADF empty sensor.
When this simulation is executed, the RADF empty sensor is adjusted and the adjustment value is
displayed.
Description
8 – 19
Ref. Page