The screen is not displayed even though the POWER LED is on
(continued)
B Perform a soft reset by pressing the RESET button of your CLIÉ handheld.
b
For details, refer to "Basic operations of your CLIÉ
™
CLIÉ
handheld" in the supplied "Read This First (Operating Instructions)".
My CLIÉ handheld does not respond
B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode?
Your CLIÉ handheld does not operate when the POWER/HOLD switch is
in HOLD mode. Make sure you release HOLD mode.
B Is your CLIÉ handheld placed near the IR port of your computer?
Move your CLIÉ handheld away from the IR port of your computer except
when performing the IR HotSync
You can also disable the IR feature by selecting [Off] next to [Beam
Receive:] in the Preferences screen for [General].
B Perform a soft reset by pressing the RESET button of your CLIÉ handheld.
b
For details, refer to "Basic operations of your CLIÉ
™
CLIÉ
handheld" in the supplied "Read This First (Operating Instructions)".
My CLIÉ handheld keeps turning itself off
B Your CLIÉ handheld is designed to turn itself off after a period of inactivity
(Automatic power-off). You can set the automatic power-off time by
selecting a time for [Auto-off After:] in the Preferences screen for
[General].
Note
The maximum idle time is 3 minutes.
b
For details, refer to "Customizing your CLIÉ
automatic power-off time" in the "Handbook" (PDF format).
™
handheld: Restarting your
®
operation, as a malfunction may occur.
™
handheld: Restarting your
™
handheld (Preferences): Setting the
Continued on next page
• • • • • • • • • • • • • • • • • • • •
13