Table of Contents
Advertisement
Faults and what to do about them
en
Information on the display panel
Fault code
‹˜"¯
"‚
"†
"‡ ˜—¯˜
—Ÿ –©'š
•‚ "Ÿš
–‹ "Ÿš
Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the
after sales service.
Faults and what to do about them
Fault
Programme does not
start
The maximum spin
speed cannot be set.
The water is not
Drained.
Detergent residues in
the detergent drawer.
46
The door is not properly closed. Close the door.
The water control system has been activated. Disconnect the appliance from the
mains, turn off the tap and advise the after-sales service.
Water is not entering the appliance. See the fault Water is not flowing in
The water is not Drained. See the fault Water is not Drained
Not a fault! The unbalanced load detection system has detected an unbalanced
load caused by laundry items. The fluff removal cycle cannot start. Remove the
laundry.
Maximum or minimum drying load not taken into account. HI/End or LO/End
flash alternately in the display. See information for the Drying result not satisfac-
tory fault..
Possible cause
The Start/Pause I button has not
been pressed.
A delayed start time has been selected.. Washer dryer starts on completion
Power cut.The delayed start time that
was selected has been cleared.
The door is not properly closed.
Plug not inserted properly into socket.
The maximum spin speed depends on
the programme selected.
Drain hose is twisted..
Detergent pump is blocked.
Damp or lumpy detergent.
Remedial Action
Press the Start/Pause I button.
ofthe delay period. Change the "finished
in time" if necessary.
Reselect the delayed start time or start-
the programme immediately. Press the
Start/Pause I button.
Close the door.
Insert plug correctly
Change programme as required.
Fit the Drain hose correctly.
Clean the Drain pump .
Clean and dry the detergent drawer .
Use the measuring aid for liquid deter-
gent.
Advertisement
Table of Contents
