Table of Contents
Advertisement
Cleaning and maintenance
en
The drain hose at the siphon
is blocked
Set the program selector to Off. Pull
1.
out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select the q Rinse0Spin button and
2.
start the program. Allow to run for
approx. 40 seconds.
Set the program selecor toOff
3.
Pull out the mains plug.
4.
44
Clean the filters:
Disconnect the hose from the rear of
1.
the appliance.
Use pliers to remove the filter.
2.
Clean the filter with a small brush.
3.
Connect the hose and check for
4.
leaks.
Advertisement
Table of Contents
