Table of Contents
Advertisement
Information on the display panel
Display
Õ
Hot
r
E:36
alternating with
-10 and End
when programme is
finished
H:95
alternating with
End
when programme is
finished
H:32
alternating with
End
when programme is
finished
E (3s) lights up
Å lights up
The indicator lamp of
the Tambur Temi-
zleme (Drum Clean)
programme flashes
Other displays
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with A button or select Boşaltma
(Drain) programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 41
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 43
No water detected in drying phase, may get bad drying result.
Unbalance problem, spinning phase is aborted.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
Run the Tambur Temizleme (Drum Clean) 90°C programme to clean and care
for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the Tambur Temizleme (Drum Clean) information signal on/off.
■
~ "Switching the drum-care information signal on/off" on page 39
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer service.
Faults and what to do about them
en
45
Advertisement
Table of Contents
