Table of Contents
Advertisement
Fault
Emergency release
If you cannot correct a fault yourself (switching on/off) or a repair is required:– Turn the programme selector
to Off and unplug the mains plug from the socket.– Turn off the tap and call the after-sales service –> page
24.
Possible cause
To release the door mechanically in the event of a power cut:
turn the programme selector to Off and unplug the mains plug from thesocket
■
open the base panel and Drain out the water
■
pull the emergency release downwards and open the door at the same time.
■
Before opening the door, make sure that there is no water or hot detergentsolution
in the washer dryer.
Under no circumstances open the door with the emergency release while thedrum
is still turning.
Faults and what to do about them
Remedial Action
en
49
Advertisement
Table of Contents
