Table of Contents
Advertisement
Drain the water. ~ Page 42
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
Information on the display panel
Display
Õ
Hot
r
E lights up
Å lights up
E:18
E:35
alternating with
-10
(Suitable for special
models)
E:95
alternating with
End
when programme is
finished
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with Start/Reload A button or
select 0 Spin.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the temperature in the drum has dropped.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked? ~ "Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 42
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 43
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
No water detected in drying phase, may get bad drying result.
Faults and what to do about them
en
45
Advertisement
Table of Contents
