Table of Contents
Advertisement
Publication no. 201102
Calibrate
Left arrow
Right arrow
Exposure display pattern
Here different patterns that will be displayed on the exposure display can be selected.
Normal
FRAME C1
FRAME C1N
Opening length. Here the length of the lid can be set. Normally this is 114 but if a cassette
Information on the display
The following information is displayed on the display.
POS
SPEED
RPT CNT
SENSORS
September 2003
Runs a calibration. The camera is not able to sense when the carriage is in
its home position. Instead a calibration cycle is run each time the camera is
switched on and at the end of each opening cycle. The calibration cycle
means that the motor is run slowly leftwards until the movement is blocked
because the carriage hits the left end stop. Then a short movement right fol-
lowed by yet a left movement (slower this time) until the left end stop is hit
again. If the position is the same (with some margins) both time the position
is set to 0 and the motor unit is considered calibrated. This operation has to
be performed either by using this function or by switching the camera off and
on again each time the motor is rotated manually since the camera is not able
to keep track of the position. It counts pulses but it is not able to find if the
carriage moves left or right.
The speed of the motor can be set in step of 8 by pressing the left or right
arrow keys. Positive speeds are cause movements to the right, negative to
the left. The left arrow key will subtract 8 from the speed.
The speed of the motor can be set in step of 8 by pressing the left or right
arrow keys. Positive speeds are cause movements to the right, negative to
the left. The left arrow key will add 8 to the speed.
Display the content of the operator display. Note that the exposure display
is not switched on until either any of the opening functions described
above is performed or until the selection is changed to something else and
then back again.
Display a three pixel wide frame matching the size of a picture when a cas-
sette with the C1 window is used. This means that the entire area of the
exposure display is used.
Display a three pixel wide frame matching the size of a picture when a cas-
sette with the C1N window is used. This means that the entire area of the
exposure display except for 16 lines at the top is used.
with a lid shorter then normal is used, the value can be changed here.
Shows the position of the carriage. Note that the camera is not able to deter-
mine the direction of a movement if the motor is run by hand. The pulse count
will change but it will increase or decrease (depending on the direction of the
last motor movement) regardless of which direction the motor is moved.
Tells which speed the motor is running. Positive speed means movement to
the right, negative speeds movement to the left. The value is updated once a
second.
Counts the number of opening cycles run by the repeat function of the cam-
era.
Shows the status of the three cassette sensors. A 0 means sensor not acti-
vated, 1 means sensor activated. Left digit is left sensor and so on. Updated
once a second. For adjustment of the sensors the Sensor adjustment window
is recommended.
38
NIC2-2 · Network ID Camera
Triacon AB Sweden
Advertisement
Table of Contents
