Table of Contents
Advertisement
Electric Lock Connection
Door Lock Controlled with Internal Power
Note:
1.
Electronic lock of Power-on-to-
unlock type should be used.
2.
The door lock is limited to 12V, and
holding current must be less than
250mA.
3.
The door lock control is not timed
from Exit Button(EB).
4.
The Unlock Mode Parameter of
Monitor must be set to 0 (by default).
Door Lock Controlled with Dry Contact
Note:
1.
The external power supply must be used
according to the lock.
2.
The inside relay contact is restricted to
AC or DC 24V/1A.
3.
The jumper must be taken off before
connecting.
4.
Setup the Unlock Mode of Monitor for
different lock types.
• Power-on-to-unlock type:Unlock
Mode=0 (by default)
• Power-off-to-unlock type:Unlock
Mode=1
1 2 3
Jumper position in 2-3
L1
L2
PL
Jumper
L1
L2
-4-
S1+ GND
Take off the
PL
S1+ GND
LOCK
Advertisement
Table of Contents
