Related Manuals for Tador MOON9-KIT
Summary of Contents for Tador MOON9-KIT
- Page 1 English MOON9-KIT 2-Wire Video Outdoor Station User Manual Moon-9-KIT ( Panel + Monitor ) 2-wires door entry kit...
-
Page 4: Electric Lock Connection
Electric Lock Connection Door Lock Controlled with Internal Power Note: 1 2 3 Electronic lock of Power-on-to- unlock type should be used. Jumper position in 2-3 The door lock is limited to 12V, and holding current must be less than S1+ GND 250mA. -
Page 6: Multi Monitors Connection
Multi Monitors Connection Basic IN-OUT Wiring Mode Code=15 Code=14 Code=0 (Device Address:0) - Page 7 With DBC4A1 Wiring Mode Impedan Code=14 Code=15 OFF ON switch Code=13 Code=12 Code=2 Code=3 OFF ON Impedance switc Code=1 Code=0 100~240VAC PC6A BUS(IM) BUS(DS) (Device Address:0)
-
Page 8: Pan-Tilt & Zoom
5. Pan-tilt & Zoom Note that this function requires the monitor with fish-eye function to support. It is available to adjust the display mode for viewing images at a fish-eye door station by using the 5 direction pad button. When an image at a door station is displayed,move to the desired position by touching on the screen to view the image in zoom mode. -
Page 9: Functions Setting Up
6. Functions Setting Up This section explains the settings of each function, please refer to the following table: About the setting mode: Input the master code to switch to the setting mode, and input the corresponding setting code to perform the settings for the function you want. After settings have been made, input the following setting codes to continue the setting operation. - Page 10 How to What to type Additional information Return panel settings to factory 1234*00*1234* Unit will return to the factory mode settings Change Programing code 123*01*1234* this will change the default programming code ( 1234* ) In case changing the code please keep it in a safe place Add an additional opening code 1234*20*(code)*...
-
Page 11: Opening The Door
Special settings Dial all of the monitors *1234*100*0* This will set the panel to dial all simultaneously of the monitors which are in the address 0 – 32 simultaneously. Dial a specific monitor *1234*100*1*05* In this example it will set the panel to dial monitor which has number "5"... -
Page 12: Unlock Operations
9.Unlock Operations Unlocking of user code When the registered user code has been input using the keypad (1~12 digits), the LED background indicator lights up, the buzzer sounds,and the electric door strike is unlocked.(note that you should press "#" button(if "#" button is set to confirm button) after input the unlock code) •... -
Page 13: Cables Requirements
11.Cables Requirements The maximum distance of the wiring is limited in the DT system. Using different cables may also affect the maximum distance which the system can reach. The farest monitor monitor with two or four monitors monitor monitor DBC4A1 100~240VAC When Monitor quantity <... - Page 14 12. Precautions • Please clean the unit with soft cotton cloth don't use the organic impregnant or chemical clean agent. If necessary, please use a little pure water or dilute soap water to clean the dust. • The unit is weather resistant. However do not spray high pressure water on access control keypad directly.
-
Page 15: Android Application
Additional information IOS Application Android Application only if using only if using wifi monitor wifi monitor -19-... - Page 16 The design and specifications can be modified without notice to the user. Right to interpret and copyright of this manual are reserved. Moon-9-KIT ( Panel + Monitor ) 2-wires door entry kit -20-...