Troubleshooting; On-Screen Messages - Sony SDM-P232W Operating Instructions Manual

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 20.
If "Not supported signal" appears on the screen
This indicates that the input signal is not supported by the
monitor's specifications. Check the following items.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 20.
INFORMATION
Not supported signal
xxx.x kHz / xxx Hz
If "xxx.x kHz / xxx Hz" is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
If "Resolution too high / Set to 1920
displayed
This indicates that the resolution is not supported by the
monitor's specifications (1920 1200 or less).
If "No input signal" appears on the screen
This indicates that no signal is being input via the currently
selected connector.
INFORMATION
No input signal
Go to power save
Go to power save
The monitor will enter the power saving mode after about 5
seconds from the time the message is displayed.
If "Cable disconnected" appears on the screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
1: HD15
1200" is
1: HD15
INFORMATION
Cable disconnected
Go to power save
Go to power save
The monitor will enter the power saving mode after about 5
seconds from the time the message is displayed.
1: HD15
US
19