A Misfeed in the paper feed area
B Misfeed in the fusing area
Fusing unit release lever
01C-5.p65
Downloaded from:
http://www.usersmanualguide.com/
Gently remove the misfed paper from the paper feed area as shown in the illustration.
When
blinks in the display and the misfed paper is not seen from the paper feed
area, pull out the paper tray and remove the misfed paper. If the paper cannot be
removed, proceed to "B Misfeed in the fusing area".
The fusing unit is hot. Do not touch the fusing unit when removing misfed
paper. Doing so may cause a burn or other injury.
Do not touch the photoconductive drum (green portion) when removing the
●
misfed paper. Doing so may damage the drum and cause smudges on copies.
If the paper has been fed through the bypass tray, do not remove the misfed
●
paper through the bypass tray. Toner on the paper may stain the paper
transport area, resulting in smudges on copies.
Close the side cover by pressing the round projections near the side cover open
button. The misfeed (
) indicator will go out and the ready (
up.
Lower the fusing unit release lever by rotating it all the way as shown in the illustration.
While you are lowering the fusing unit release lever, it will not move smoothly
at a location on the way. However, be sure to lower the lever by rotating it all
the way to the location where it will not rotate as shown in the right illustration.
27
MISFEED REMOVAL
) indicator will light
2/11/00, 15:57
5
27